Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
Install the impact bolster - 1 - and tighten the bolt - 2 -.
-
Install the trim cover on the driver side, as well as the cover under the trim cover.
-
Install the hose/line assembly or plastic line - 1 - with a new seal - 2 - to the master cylinder connection - 4 - until the securing clip - 3 - engages
audibly.
-
Gently pull on the line to check installation.
-
Remove the (3094) and bring the supply hose back to its original shape.
-
Bleed the clutch system. Refer to => [ Clutch System, Bleeding ] See: Clutch Hydraulic System/Service and Repair/Procedures.
-
Install the battery.
-
Install the entire air filter housing.
Tightening Specifications