Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-2106022.png)
-
Remove the noise insulation.
-
Remove the crossmember.
-
Remove the floor panel trim.
-
Disconnect the front exhaust pipe at the double clamp and remove it from the subframe.
-
Disengage the rear exhaust system and remove the heat shield.
-
Pivot the shift housing downward and remove it with the cables.
Installing
Install in reverse sequence; note the following points:
-
Align the shift housing parallel to body.
‹› Distance to the body must be the same on both sides.
Tightening specifications for the shift housing nuts, refer to - item 26 -=> [ Nut ] See: 02Q Transmission/Shift Mechanism Overview or - item 16 -=>
[ Nut ] See: 02Q Transmission/Shift Mechanism Overview.
-
Route the cables - 1 - from the shift mechanism - 2 - to the transmission as follows:
