Eos (1F7) L4-2.0L Turbo (BPY) (2007)
3
Bolt with Spring
‹› 3 Nm
4
Pin
‹› Removing, refer to => [ Selector Lever Cable, through 02.2009 ] See: Shift Linkage/Shift Cable/Service and Repair/02E Transmission (Direct
Shift Gearbox).
‹› Do not grease
5
Securing Plate
‹› Always replace after removal.
6
Nut
‹› 9 Nm
‹› Quantity: 4
7
Shift Housing
‹› With seal
8
Retaining Washer
‹› Always replace after removal.
9
Retaining Washer
‹› Always replace after removal.
10
Selector Lever Cable
‹› Do not grease the cable.
‹› Removing and installing, refer to => [ Selector Lever Cable, through 02.2009 ] See: Shift Linkage/Shift Cable/Service and Repair/02E
Transmission (Direct Shift Gearbox).
‹› Checking, refer to => [ Selector Lever Cable Checking, through 02.2009 ] See: Automatic Transmission/Transaxle/Shift Linkage/Shift
Cable/Testing and Inspection.
‹› Adjusting, refer to => [ Selector Lever Cable Adjusting, through 02.2009 ] See: Automatic Transmission/Transaxle/Shift Linkage/Shift
Cable/Adjustments.
11
Bolt with Washer
‹› 8 Nm
‹› Quantity: 4
Shift Handle With Cover
Shift Handle with Cover
There is the possibility that the button can be pushed into the handle. Do not install the handle with the button pushed in.
-
Pull the button out beyond its press point before removing.