Eos (1F7) L4-2.0L Turbo (CBFA) (2008)
5
O-ring
‹› Always replace
6
Valve Unit
7
Oil Filter Element
‹› 22 Nm
‹› Remove and install using oil filter wrench (3417).
8
Bolt
‹› 15 Nm
9
Connection
10
Seal
‹› Always replace
11
Oil Cooler
‹› See note, => [ If large quantities of metal particles
or abraded material are detected during engine repairs, it may mean
the crankshaft or rod bearings are damaged. To prevent further damage,
perform the following steps after the repair: ] See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Oil Pan/Service and Repair/Oil Pan and
Pump Overview.
‹› Ensure sufficient clearance to surrounding components.
‹› Coolant hose connection diagram. Refer to => [ Coolant Hose Connection Diagram ] See: Diagrams/Mechanical Diagrams/Cooling
System/System Diagram.
‹› Removing and installing, refer to => [ Oil Cooler ] See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Oil Cooler/Service and
Repair.
12
Gasket
‹› Always replace
13
Bolt
‹› Tightening sequence, refer to => [ Accessory Bracket Bolt Tightening Sequence
and Specification ] See: Drive Belt/Service and Repair/Ribbed Belt Overview.