Eos (1F7) L4-2.0L Turbo (CBFA) (2008)
Impact Sensor: Service and Repair
Front Door Crash Sensors
‹› Removal and installation is described for the right-hand side of the vehicle. Removal and installation for the left-hand side is performed in the
same manner.
Removing
CAUTION!
Observe safety precautions for working on airbags.
-
Disconnect vehicle battery.
-
Remove corresponding door trim:
‹› Driver's side, refer to => [ Driver Door Trim ] See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and
Repair/Driver Door Trim
‹› Passenger's side, refer to => [ Passenger Door Trim ] See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service
and Repair/Passenger Door Trim
-
Separate wiring harness - 1 - from crash sensor - 3 -.
-
Remove the two bolts - 2 - (2.5 Nm).
Installing
-
Perform the steps used for removal in reverse order.
-
Switch on ignition.
CAUTION!
Make sure that no one is in the vehicle.
-
Connect vehicle battery.