Eos (1F7) L4-2.0L Turbo (CBFA) (2008)
^
Slide joint piece over rollers and secure.
^
Press 60 grams of joint grease, from repair kit, into the reverse side of the triple roller joint.
^
Install CV boot.
Mount triple roller star
Cylindrical drive axle
^
Install triple roller star onto shaft and press on until stop.
^
Make sure pressure does not exceed 3.0 t!
^
If necessary, coat drive axle splines and triple roller star using solid lubricant G 052 142 A2.
^
Insert securing ring, be sure to fit properly.
^
Press 70 grams of joint grease from repair set, into triple roller joint.
^
Slide joint piece over rollers and secure.
^
Press 60 grams of joint grease, from repair kit, into the reverse side of the triple roller joint.
^
Install CV boot.
^
Tighten both clamps using pliers hose clamp pliers V.A.G. 1275.