Eos (1F7) L4-2.0L Turbo (CBFA) (2008)
-
Install the stub or flange shaft.
-
Install a new bolt for securing the stub or flange shaft and tighten it to 30 Nm.
Vehicles with a Intermediate Shaft
-
Replace the O-ring on the stub shaft.
-
Grease the splines on the stub shaft using grease for clutch disc splines (G 000 100).
-
Guide the intermediate shaft - B - through the mounting bracket - C - onto the transmission stub shaft.
-
Tighten the intermediate shaft to mounting bracket bolts - arrows -.
Continuation for All Vehicles
-
Install the right drive axle.
-
Install the right wheel.
-
Change the Direct Shift Gear (DSG) oil. Refer to => [ Oil Filter, Changing and Oil Level, Adjusting ] See: Automatic
Transmission/Transaxle/Fluid Filter - A/T/Service and Repair/Oil Filter, Changing and Oil Level, Adjusting.
-
Install the noise insulation.
Left Flange Shaft and Seal
Left Flange Shaft and Seal