Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
-
Run roof with convertible top opening switch until rear lid with rear shelf is open halfway.
-
Press roof pillar flap by hand slightly so that screw - 2 - can be accessed.
-
Disconnect wiring connection - 3 -.
-
Remove screw - 2 - and remove sensor - 1 - from roof pillar flap - 4 -.
Tighten screws - 2 -: 3 Nm.
Rear Shelf Lock Sensors
Rear Shelf Lock Sensors
‹› All screws are microencapsulated and must always be replaced.
‹› Sensor consists of 2 parts, magnet is secured on locking hooks in assembly carrier.