Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
11
Connecting Rod
‹› Only replace as a set.
‹› Mark affiliation to the cylinder - A -.
‹› Installed position: the marks - B - face the belt pulley side.
Piston Ring Gap, Checking
-
Push the ring squarely from above down to approximately 15 mm from the bottom end of the cylinder. To do this use a piston without rings.
Piston Ring Groove Clearance, Checking
-
Clean the ring groove of the piston before checking.