Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
-
Immediately install the lower oil pan and tighten the bolts - 1 through 20 - in three passes as follows:
1 - Tighten the bolts hand-tight
2 - Tighten the bolts to 8 Nm
3 - Tighten the bolts an additional 45° (1/8) turn
‹› After installing the oil pan, allow the sealant to dry for approximately 30 minutes. Only after then may the engine oil be added.
-
Fill the engine oil, capacities, refer to => [ Engine Oil ] See: Engine Oil/Description and Operation.
The rest of the installation is basically a reverse of the removal sequence.