Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
/l4-2.0l_turbo_(ccta)/Page-387003.png)
-
Install the retainer (VAS 5161/6) using 2 guide forks M6/M8 (VAS 5161/5) into the outer thread of the guide plate (VAS 5161/19B).
-
Press down the assembly cartridge (VAS 5161/8). At the same time, turn the knurled screw of the assembly cartridge (VAS 5161/8) clockwise
until the points engage in the valve retainers.
-
Lightly move the knurled screw back and forth, this causes the valve retainers to be pressed apart and captured in the assembly cartridge (VAS
5161/8).
-
Release the pressure fork with lever for assembly cartridge (VAS 5161/2).
-
Take out the assembly cartridge (VAS 5161/8).
-
Remove the valve stem seal using the valve seal removal tool (3364).
-
If the valve seal removal tool (3364) cannot be used due to restricted clearance, drive the roll pin - arrow - out with a drift and remove the impact
attachment.
