Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
Installing
‹› Because of the small clearance between the balance shaft and cylinder block, the balance shaft may need to be cooled in order to install it. Check if
the balance shaft can be installed into the cylinder block without forcing it in. If it cannot, the balance shaft must be cooled before installing it.
‹› Tightening specifications, refer to => [ Balance Shaft Timing Chain Overview ] See: Balance Shaft Chain/Service and Repair/Balance Shaft
Timing Chain Overview.
-
Place the new balance shaft in a freezer for 30 minutes or spray it with commercially available cooling spray.
-
Lubricate the balance shaft bearing with engine oil.
-
Install the new intake camshaft shim and tighten the bolt - 2 -.
-
Replace the O-ring - 1 - and lubricate with engine oil.