Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
-
Insert a steel wire (approximately 1.2 mm) into the hole - arrow - next to the ignition key.
-
Using the steel wire - 2 -, release - arrow - the retaining lever - 3 - of the lock cylinder - 1 -.
-
Remove the lock cylinder - 1 - from the steering lock housing.
Installing:
-
Disconnect harness connector - arrow - at induction coil.
‹› To improve clarity, the ignition key is not shown in the following illustration.
-
Insert the ignition key into the lock cylinder - 1 - and turn it to the Run position.