Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
‹› While removing, the complete rain/light recognition sensor and not only the upper shell of the sensor must be pried off.
Installing:
Install in reverse order of removal, noting the following:
CAUTION!
‹› Always clean the windshield surface inside the Rain/Light Recognition Sensor bracket before installing. Remove any traces of the
connecting pad still remaining on the windshield.
‹› Surface (connecting pads) of rain/light recognition sensor must not be soiled or damaged when installing. Always replace a sensor that
has a damaged connecting pad.
‹› If the surface (connecting pads) of rain/light recognition sensor is soiled, it can be potentially cleaned by applying and then pulling off one or more
adhesive strips.
-
Clean windshield inside retaining plate, cleaning solution.
-
Where applicable, remove the cap from the new rain/light recognition sensor.
-
Insert the rain/light recognition sensor - 1 - into the retaining plate - 2 - on the windshield and press it in securely.