Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
-
Remove the starter downward and out from the vehicle.
Installing:
Install in reverse order of removal, noting the following:
‹› All hose connections for charge air system are secured by spring-type clamps or by connector couplings. The following must be observed with
connector couplings:
‹› Connect hose/pipe without tools.
‹› Make sure retaining tabs lock securely - arrow -.
-
Tighten all threaded connections to the specification shown in => [ Starter Tightening Specifications ] See: Specifications.
2.0L DSG
Starter
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1331)
‹› Torque Wrench (V.A.G 1332)
Removing:
-
Disconnect battery, refer to => [ Disconnecting and Connecting Battery In Engine Compartment ] See: Battery/Service and Repair/Removal and
Replacement/Disconnecting and Connecting Battery In Engine Compartment.
-
Remove noise insulation.
-
Remove screws - arrows -.