Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
/l4-2.0l_turbo_(ccta)/Page-990008.png)
This prevents damage to the control module - 1 -.
Installing
Installation is performed in the reverse order of removal.
The steering gear threaded sleeves must be seated in the console holes.
‹› Coat seal on steering gear with lubricant, e.g. soft soap, before installing steering gear.
‹› After attaching steering gear to drive axle, make sure that seal on steering gear is positioned to mounting plate without kinks and opening to foot
well is sealed correctly. Ingress of water and/or noises may be the result.
‹› Make sure sealing surfaces are clean.
Before fastening the bolts for subframe, position steering gear on subframe and fasten bolts for steering gear and stabilizer.
-
Clamp off the electrical connections to the steering gear.
-
Install lower noise insulation.
‹› Make sure that the ball joint boot is not damaged or twisted.
-
Bolt universal joint to steering gear.
-
Connect battery.
-
Perform the basic setting for the steering angle sensor (G85) using the (VAS 5051).
If a new steering gear was installed, then the electro-mechanical steering must be adapted with the (VAS 5051).
-
Adapt the electro-mechanical steering with the (VAS 5051 ).
Suspension
Electro-mechanical Steering
01 - On-Board Diagnostic (OBD) Capable System
Electro-mechanical Steering
Functions
Adaption to Electro-mechanical Steering
After installation, position of steering wheel must be checked with a road test.
