Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
Suspension Control Module: Service and Repair
Electronic Damping Control Module
Electronic Damping Control Module
Removing
‹› Component location: Behind the left side luggage compartment trim panel.
-
Switch off all electrical consumers.
-
Remove the ignition key.
-
Remove the left side trim in the luggage compartment.
-
Release and disconnect the connector.
-
Slightly bend the tabs on the bracket - arrows - upward and slide the electronic damping control module (J250) in - direction of arrow - out of
the bracket.
Installing
Installation is the reverse of removal, with special attention to the following:
-
Slide the electronic damping control module far enough into the bracket so that the tabs - arrows - audibly latch into place.
-
Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Suspension Control ( Automatic -
Electronic )/Testing and Inspection/Programming and Relearning.