Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
-
Loosen drive axle bolt to wheel hub. Refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service
and Repair/Procedures.
-
Remove wheel.
-
Remove the level control system sensor from the control arm.
-
Remove the nut - arrow - of the connecting link from suspension strut.
-
Remove nuts - arrows -.
-
Pull wheel bearing housing with ball joint out of control arm.
-
Pull outer joint of drive axle out of wheel hub.
-
Secure drive axle to body using wire.
‹› The drive axle must not hang down, otherwise the inner joint will be damaged by overflexing.
-
Bolt ball joint to control arm again.
-
Fasten (V.A.G 1383 A) using (T10149) to wheel hub with a wheel bolt.