Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
/l4-2.0l_turbo_(ccta)/Page-632002.png)
Installing
Installation is performed in the reverse order of removal. Pay attention to the following:
‹› Replace stub shaft countersunk bolt.
-
Remove sealing ring - A - from groove - arrow - and replace.
-
Carefully drive stub shaft in, turning while doing so.
-
Secure stub shaft with new countersunk bolt and tighten to 30 Nm.
-
Install right drive axle.
-
Check transmission oil level. Refer to => [ Oil Filter, Changing and Adjusting Oil Level ] See: Fluid - A/T/Service and Repair.
Tightening Specifications
