Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
/l4-2.0l_turbo_(ccta)/Page-711004.png)
-
Fill the area between the sealing lip and dust lip - arrow - halfway with sealing grease (G 052 128 A1).
-
Drive in the new seal until seated using the (VW 423).
The rest of the installation follows the reverse order of removal, noting the following:
-
Install the transmission selector lever to the selector shaft of the transmission, refer to => [ Transmission Shift Lever,
Installing ] See: Shifter M/T/Service and Repair/Removal and Replacement/02Q Transmission/Shift Mechanism Overview and tighten the nut - item 17
-=> [ Self Locking Nut ] See: Shifter M/T/Service and Repair/Removal and Replacement/02Q Transmission/Shift Mechanism Overview to specification.
-
Install the air filter housing, if it was removed earlier.
