Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
Shift Cable: Service and Repair
02E Transmission (Direct Shift Gearbox)
Selector Lever Cable, Through 02.2009
Selector Lever Cable, through 02.2009
‹› After installation, the cable must be checked for ease of movement and must be adjusted.
Removing
-
Place the selector lever in the "S" position.
Loosen the cable adjustment bolt - arrow -.
-
Remove the lock washers - A and B -. The lock washers must later be replaced when adjusting the cable.
-
Raise the vehicle.
-
In order to remove the cable and/or selector mechanism, the heat shield and if necessary exhaust system components must now be removed.
-
Remove the heat shield.
-
Remove the shift mechanism housing nuts beneath the selector lever.