Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
‹› If this cannot be done because of a power window malfunction, remove the window regulator motor and then slide the window down.
-
Raise rear door window - 1 - and swing back and up out of door in - direction of arrow -.
Installing
-
Guide door window - 1 - without pressure - arrow - into clamping brackets and front window guide.
-
Clean the bolt threads and coat them with locking compound (D 000 600 A2).
-
Tighten clamping screws - 2 and 4 -, tightening specification: 6 Nm.
-
Adjust door window, refer to => [ Door Window, Adjusting ] See: Adjustments/Door Window, Adjusting
-
Continue by performing the steps used in removal in reverse order.
‹› Check the window function before installing the door trim.
Window Regulator Motor
Removing