Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Brakes and Traction Control > Antilock Brakes / Traction Control Systems > Electronic Brake Control Module > Component Information > Service and Repair > ABS Mark 70, ABS and ASR > Page 3878
Electronic Brake Control Module: Service and Repair
Control Module and Hydraulic Unit
Sealing Plug Repair Set, Part No. 1H0 698 311 A
Transport protection for valve domes (foam)
Sealing plug M10
Sealing plug M12
After separating the control module from the hydraulic unit, always install the transport protection - 1 - on the hydraulic unit for the valve domes.
Warranties will not be granted for hydraulic units without transport protection.
The control module is bolted to the hydraulic unit and is located on the right side in the engine compartment.
Read and note the present control module coding.
Note or request radio code on vehicles with a coded radio, if necessary.
Disconnect the battery.
Remove the engine cover.
If equipped, remove the heat shield.
Release the control module connector in - direction of arrow 1 - and pull off in - direction of arrow 2 -.
|[PREV PAGE] [NEXT PAGE]|