Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Brakes and Traction Control > Disc Brake System > Brake Rotor/Disc > Component Information > Technical Service Bulletins > Customer Interest for Brake Rotor/Disc: > 4610-05 > Oct > 10 > Brakes - Vibration/Pulsation Upon Application > Page 4057
Remove wheels and separate brake calipers from carrier as outlined in Repair Manual Group 44 - Wheels, Tires, Vehicle Alignment and Group 46 -
Brake Disc Inspection
A detailed brake disc inspection is needed to determine if the brake disc should be machined or replaced. Inspect brake disc friction surfaces on both
Severe discoloration (bluing)
High heat surface damage (raised hard spots)
Brake discs showing any of the above described conditions MUST be replaced.
Disc Thickness Measuring
Each brake disc has the minimum allowed thickness cast, stamped or laser-etched into the disc hub.
Measure the brake disc thickness in 4 locations using either the Pro Cut International(TM) disc thickness measuring tool Part No. 50-902 or the
Brake Disc Machining
|[PREV PAGE] [NEXT PAGE]|