![]() |
Volkswagen Workshop Manuals | |
Eos (1F7) V6-3.2L (BUB) (2008)Brakes and Traction Control > Hydraulic System, Brakes > Hydraulic Control Assembly - Antilock Brakes > Component Information > Service and Repair > ABS/ASR/Mark 70 Control Module and Hydraulic Unit > Page 4152![]() ^ Install brake pedal loading device V.A.G. 1869/2. ^ Attach bleeder hose of bleeder bottles to left-front and left-rear brake caliper bleeder valves and open bleeder valves. ^ Operate brake pedal using brake pedal depressor V.A.G. 1869/2 at least 60 mm. ^ Close left front and left rear bleeder valves. ^ Do not remove brake pedal loading device V.A.G. 1869/2. ^ Place sufficient lint-free cloths under the control module and hydraulic unit. Make sure that brake fluid does not come in contact with the terminals. ^ First, mark both brake lines from master cylinder - A and B - and remove from the hydraulic unit. ^ Plug the brake lines and threaded holes immediately with sealing plugs from the repair kit Part No. 1H0 698 311 A. ^ Mark brake lines (brake caliper) - 1 to 4 -, unscrew and seal. ^ Pull hydraulic unit with control module upward out of shock absorbers. Removing Control Module, from Hydraulic Unit Note: Separation from control module and hydraulic unit is not possible on vehicles with hydraulic brake booster or hill assist. ^ Set hydraulic unit with control module downward on to a clean, level surface. ^ Unscrew inner Torx bolts E 5 -arrows- from hydraulic pump. CAUTION! ^ For this reason, secure hydraulic pump to hydraulic unit using red retainer - 1 - from replacement part set and two sealing plugs - 2 -. Brakes and Traction Control > Hydraulic System, Brakes > Hydraulic Control Assembly - Antilock Brakes > Component Information > Service and Repair > ABS/ASR/Mark 70 Control Module and Hydraulic Unit > Page 4152 | ||
[PREV PAGE] [NEXT PAGE] |