Eos (1F7) V6-3.2L (BUB) (2008)
-
Remove the pump downward from the rubber bracket loops. Spray the rubber loops with silicone free lubricant if necessary.
-
Remove the after run coolant pump bracket.
-
Unclip the wire harness retainer from the right side of the coolant pipe.
-
Remove the wire harness from the left side retainer on the coolant pipe.
-
Remove the coolant hose from the oil cooler and coolant pipe.
-
Remove the coolant pipe from the cylinder block.
Installing
Installation is performed in the reverse order of removal, noting the following:
‹› Replace O-rings.
-
Clean and/or smooth O-ring sealing surface in cylinder block before installing.
-
Lubricate the new O-ring - 1 - with coolant and slide it onto the coolant pipe - 2 -.