Eos (1F7) V6-3.2L (BUB) (2008)
-
Disconnect the Engine Coolant Temperature (ECT) Sensor G62 electrical harness connector - 1 -.
-
Using a jumper wire, connect the Engine Coolant Temperature (ECT) Sensor G62 electrical harness connector terminals 1 to 2.
-
Check the value indicated on the scan tool display.
If the value jumps to approx. 140.0 degrees C
-
End diagnosis and switch the ignition off.
-
Replace the Engine Coolant Temperature (ECT) Sensor G62.
If indication remains at approx. -40.0 degrees C:
Testing if display approx. 140.0 degrees C:
-
Disconnect the Engine Coolant Temperature (ECT) Sensor G62 electrical harness connector - 1 -.
If indication jumps to approx.- 40.0 degrees C:
-
End diagnosis and switch ignition off.
-
Replace the Engine Coolant Temperature (ECT) Sensor G62.
If indication remains at approx. 140.0 degrees C:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin VAG1598/31.
If the manufacturers test box is not being used. Perform the following step.