Eos (1F7) V6-3.2L (BUB) (2008)
Variable Valve Timing Actuator: Service and Repair
Camshaft Adjuster Valves
Camshaft Adjuster Valves
Special tools, testers and auxiliary items required
‹› Socket Wrench (T10072)
‹› TORX Bit Set (V.A.G 1766)
‹› Torque Wrench (5-60 Nm) (V.A.G 1783)
‹› Ratchet Insert 1/4" (VAS 6234)
Removing
-
Remove the intake manifold. Refer to => [ Intake Manifold ] See: Intake Manifold/Service and Repair/Intake Manifold.
-
Disconnect the 2 pin connector from the Engine Coolant Temperature (ECT) sensor (G62)- arrow -.
-
Drain the coolant. Refer to => [ Draining and Filling ] See: Cooling System/Service and Repair/Procedures/Draining and Filling.
-
Remove the thermostat housing. Refer to => [ Coolant Thermostat Housing Overview ] See: Cooling System/Thermostat/Service and
Repair/Coolant Thermostat Housing Overview.
-
Remove the cylinder head cover. Refer to => [ Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service and Repair/Cylinder
Head Cover.
‹› Mark the connector assignment to the component before disconnecting the connectors.
-
Disconnect the connectors from the Camshaft Position (CMP) sensor (G40) - 1 - and CMP sensor 2 (G163) - 2 -.