Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Engine, Cooling and Exhaust > Engine > Camshaft, Lifters and Push Rods > Variable Valve Timing Actuator > Component Information > Service and Repair > Camshaft Adjuster Valves > Page 1859

Page 6
background image

‹›  (T10068 A) must not be installed during this process.

-

Tighten the new camshaft adjuster bolts to 60 Nm + 90° (1/4) additional turn.

If replacing the seals in the camshaft front cover, refer to => [ Camshaft Front Cover

Seal, Installing ] See: Cylinder Block Assembly/Balance Shaft Chain/Service and Repair.

-

Clean the sealing surfaces on the camshaft front cover and the cylinder head.

-

Lubricate the oil passage seal O-ring - 1 - and install it in the cover.

-

Make sure the alignment sleeves - 2 and 3 - are installed.

-

Install the seal - 4 - in the cover.

-

Clean the old sealing compound from the 3 mm holes in the cylinder head gasket - arrows -.

-

Fill the 3 mm holes in the cylinder head gasket with sealant (D 176 501 A1). Apply sealant (D 176 501 A1) to the sealing surfaces on the cover
and install the cover immediately.

-

Install all camshaft front cover bolts - arrows - and tighten lightly.

Engine, Cooling and Exhaust > Engine > Camshaft, Lifters and Push Rods > Variable Valve Timing Actuator > Component Information > Service and Repair > Camshaft Adjuster Valves > Page 1859

[PREV PAGE] [NEXT PAGE]