Eos (1F7) V6-3.2L (BUB) (2008)
‹› The oil spray jets are installed in crankshaft bearings 2 through 7.
Removing
-
Using the 4 mm diameter drift, press the oil spray jet toward the engine bearing and out.
Installing
-
To install, press the oil spray jet - arrow - in by hand using a 6 mm diameter drift.
Oil Check Valve, Removing and Installing
Special tools, testers and auxiliary items required
‹› M8 x 1.5 Bolt
Removing
-
Install a standard M8 x 1.5 bolt approximately 4 turns into the valve - arrow - and remove the valve from the bore.
Installing
-
Lubricate the O-ring with oil before installing. Press the valve by hand into the oil passage.