Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Engine, Cooling and Exhaust > Engine > Timing Components > Crankshaft Gear/Sprocket > Component Information > Specifications > Page 2155
Crankshaft Gear/Sprocket: Service and Repair
Crankshaft Sensor Wheel, Installing
Special tools, testers and auxiliary items required
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Locking Fluid (D 154 100 A1)
Make sure the crankshaft and sensor wheel contact surfaces are free of oil and grease.
‹› The sensor wheel may only be installed once, since the attachment points - arrows - of the countersunk screws - 1 - in the sensor wheel - 2 - are so
severely deformed after installing the second time that the screw heads make contact on the crankshaft - 3 - and the sensor wheel lies loosely under
Apply a thin coat of locking fluid (D 154 100 A1) to the contact surfaces of the crankshaft and sensor wheel for additional security.
When installing, make sure that the mark VR6 - arrow - aligns with the single threaded hole.
Tighten all new bolts lightly by hand.
First, tighten bolt - 1 - to 10 Nm + 90° (1/4) additional turn.
Tighten the bolts - 2 - to 10 Nm + 90° (1/4) additional turn.
|[PREV PAGE] [NEXT PAGE]|