Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-653002.png)
11 - Chain sprocket
12 - 60 Nm + 1/4 turn (90 degree)
^
Replace
^
Use counter-holder tool T10069 to tighten and loosen.
13 - Chain tensioner with tensioning rail
^
Before installation release the locking device in the chain tensioner with a small screwdriver and press the tensioning plate against the chain
tensioner
^
Only rotate engine with chain tensioner installed
14 - Drive gear
^
Integral part of crankshaft
^
Ground down tooth aligned with main bearing joint = TDC cyl. 1.
15 - Roller chain
^
Mark direction of rotation before removing (installation position).
16 - Guide rail
^
Remove and install together with roller chain.
17 - Locating pin without collar, 10 Nm
18 - 18 Nm
19 - 23 Nm
20 - Intake camshaft adjuster
^
Identification: 24E
^
Only rotate engine with camshaft adjuster installed
21 - 60 Nm + 1/4 turn (90 degree)
^
Replace
^
Contact surface of sensor wheel at bolt head must be dry when installing
^
To remove and install, counter-hold at camshaft using an open-end wrench (32 mm).
22 - Guide rail
23 - Camshaft Adjustment Valve 1 (exhaust) N318
^
For exhaust camshaft
^
Before disconnecting, mark allocation of connector to component
24 - Camshaft Adjustment Valve 1 N205
^
For intake camshaft
^
Before disconnecting, mark allocation of connector to component
25 - Guide rail
^
For camshaft roller chain
^
Clipped in at control housing
