Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Maintenance > Filters > Fluid Filter - A/T > Component Information > Service and Repair > Oil Filter, Changing and Adjusting Oil Level > Page 1443
Fluid Filter - A/T: Service and Repair
Oil Filter, Changing and Oil Level, Adjusting
The following chapter shows how to change the oil and filter together.
If the old filter remains in the transmission, observe information on oil, refer to => [ When To Change Oil Filter ] See: Transmission and
First, the oil temperature is read. If it is higher than 50 °C (122 °F), allow the transmission to cool. With the engine off, remove the overflow tub and
Start the engine and drain any excess oil until the oil level has reached the overflow tube.
If the oil filter is being replaced, then it often necessary to create an access to the filter. The air filter housing must be removed.
Special tools, testers and auxiliary items required
‹› Vehicle Diagnosis, Testing and Information System ( VAS 5051)
‹› Adapter for Oil Filling (VAS 6262 A)
‹› Used Oil Collection and Extraction Device (V.A.G 1782) or
‹› Drip Tray (V.A.G 1306)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
The oil is obtainable as a replacement part.
‹› The engine is off.
‹› The vehicle is level and all hoist supports are the same height.
‹› Noise insulation is removed if necessary
‹› The selector level is in the "P" position.
‹› The (VAS 5051) is connected
‹› To begin working, the oil temperature should not be higher than 50 °C (122 °F).
Up to transmission production date "September 20, 2004", transmissions with two plugs were installed.
|[PREV PAGE] [NEXT PAGE]|