Eos (1F7) V6-3.2L (BUB) (2008)
Fill with 5.5 liters of Direct Shift Gear (DSG) oil.
To change bottles, shut off valve can be closed or oil filler adapter (VAS 6262) can be held higher than the transmission.
Move through Vehicle diagnostic testing and information system (VAS 5051) until DSG oil temperature is displayed.
Now start engine.
Press brake and shift into each selector lever position for approximately 3 seconds. Place lever in position "P" again.
Do not switch off engine!
With an oil temperature of 35° to 45 °C:
Disconnect the quick release coupling of the adapter for oil filling (VAS 6262) with the engine running.
Let excess oil drain.
As soon as the oil has run out (it begins to drip), remove the adapter for oil filling (VAS 6262) and install plug with new seal.
Tightening Specification: 45 Nm
Turn off engine.
Drained oil must not be used again.
Dispose of oil in an appropriate manner, refer to => [ DSG Oil ] See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/02E Transmission/General Repair Information.
This completes changing oil and filter.
Oil level in transmission is correctly adjusted.
Install noise insulation tray.