Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Maintenance > Wheels and Tires > Wheel Bearing > Component Information > Service and Repair > Procedures > Page 1755

Page 2
background image

-

Pull control arm out of lower ball joint.

-

Pull the drive axle out of the wheel hub.

-

Remove bolts - arrows -.

-

Remove wheel bearing unit from wheel bearing housing.

Installing

Installation is performed in the reverse order of removal.

-

Install brake caliper. 

-

Tighten drive axle bolt to wheel hub:

‹› Hex head bolt, refer to => [ Drive Axle Hex Bolt Connection, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and Repair/Removal

and Replacement. 

‹› Twelve point bolt, refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and

Repair/Procedures.

‹› Vehicle must not be standing on its wheels when doing this, otherwise wheel bearing will be damaged.

-

Install ABS wheel speed sensor.

-

Install wheel and tighten. Refer to => [ Wheel Bolt Tightening Specification ] See: Wheel Fastener/Specifications.

Tightening Specifications

Maintenance > Wheels and Tires > Wheel Bearing > Component Information > Service and Repair > Procedures > Page 1755

[PREV PAGE] [NEXT PAGE]