Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Power and Ground Distribution > Relays and Modules - Power and Ground Distribution > Power Distribution Module > Component Information > Service and Repair > Relay Carrier On Vehicle Electrical System Control Module, Left Instrument Panel > Page 4934

Page 3
background image

-

Remove the vehicle electrical system control module - 2 - relay carrier in - direction of arrow B - from the bracket.

Installing:

Install in reverse order of removal, noting the following:

‹› The securing latch can only be brought into the CLOSED position when all connectors are correctly connected.

‹› If a new vehicle electrical system control module is installed, it must be coded. Refer to => [ Vehicle Electrical System Control Module, Coding,

Through 05.09 ] See: Testing and Inspection/Programming and Relearning.

Relay Carrier On Vehicle Electrical System Control Module, From 06.09

‹› The relay carrier is installed depending on the vehicle equipment level. 

Removing:

-

Switch off ignition, switch off all electrical consumers and remove ignition key.

-

Remove the trim in the driver footwell.

-

Open both tabs - arrows - and pull the relay carrier -  2 - from the vehicle electrical system control module - 1 - opposite the drive direction.

-

Swing the relay carrier downward and unclip the relay. Pay attention the wire still connected.

Installing:

Install in reverse order.

Power and Ground Distribution > Relays and Modules - Power and Ground Distribution > Power Distribution Module > Component Information > Service and Repair > Relay Carrier On Vehicle Electrical System Control Module, Left Instrument Panel > Page 4934

[PREV PAGE] [NEXT PAGE]