Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Powertrain Management > Computers and Control Systems > Electronic Throttle Control Module > Component Information > Testing and Inspection > Page 2803
Specified value: 1.5 ohms max.
If the specification is not obtained:
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
If necessary, repair the faulty wiring connection.
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
If no malfunction is detected in the wiring and if the voltage supply was not OK:
Erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to => [ Readiness Code Description ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
Replace the Engine Control Module (ECM) (J623 ). Refer to => [ Engine Control Module J623, Replacing ] See: Engine Control Module/Service
Assembly is performed in the reverse of the removal.
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 03 - Read DTC Memory.
|[PREV PAGE] [NEXT PAGE]|