![]() |
Volkswagen Workshop Manuals | |
Eos (1F7) V6-3.2L (BUB) (2008)Powertrain Management > Computers and Control Systems > Engine Speed Sensor > Component Information > Locations > Page 2830![]() - Using a multimeter, check the Engine Speed (RPM) Sensor (G28) terminals 2 to 3 - B - for resistance. Specified value: 730 to 1000 ohms (at approx. 20° C) - Check Engine Speed (RPM) Sensor (G28) terminals 1 to 2 and 1 to 3 for short circuits. Specified value: infinite (infinity) If any of the specified values are not obtained: - Replace the Engine Speed (RPM) Sensor (G28). If the specified values are obtained: Checking wiring If the manufacturers test box is being used. Perform the following step. - Install the Test Box 105 Pin (VAG1598/31). If the manufacturers test box is not being used. Perform the following step. - Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module J623, Replacing ] See: Engine Control Module/Service - Using a Multimeter, check the Engine Speed (RPM) Sensor (G28) electrical harness connector terminals to the Engine Control Module (ECM) Powertrain Management > Computers and Control Systems > Engine Speed Sensor > Component Information > Locations > Page 2830 | ||
[PREV PAGE] [NEXT PAGE] |