Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Powertrain Management > Computers and Control Systems > Information Bus > Component Information > Service and Repair > Procedures

Page 1
background image

Information Bus: Procedures

CAN Bus Wires

‹› Unshielded two-strand wiring - 1 - and - 2 - with a cross section of 0.35 mm2 or 0.5 mm2can be used as CAN-Bus wiring.

‹› The color coding of CAN-Bus wires can be found in the following table:

‹› Repairs on CAN-Bus wires can be performed with repair wire with matching cross section and also with twisted wires green/yellow or

white/yellow.

‹› When repairing Bus leads, both wires must be of the same length. When twisting together wires - 1 - and - 2 -, length of lay of A = 20 mm must be

observed.

‹› While doing this, no section of the wire, e.g. in area of crimp connectors - arrow -, may be greater than B = 50 mm without twisting of the wires.

‹› Wrap repair points with yellow adhesive tape to mark a performed repair.

Powertrain Management > Computers and Control Systems > Information Bus > Component Information > Service and Repair > Procedures

[PREV PAGE] [NEXT PAGE]