Eos (1F7) V6-3.2L (BUB) (2008)
Oxygen Sensor: Service and Repair
4-Pin Heated Oxygen Sensor (HO2S)
4-Pin Heated Oxygen Sensor (HO2S)
‹› Do not repair the oxygen sensor wires. Repairing may result in malfunctions.
‹› Use the faulty sensor as a guide for installing all of the accompanying attachments, cable ties or marking bands.
‹› If necessary, identify the heated oxygen sensor (HO2S) using the protective tube. Refer to => [ Oxygen Sensor Unit Protective Pipes ] See: Power
and Ground Distribution/Wiring Harness/Description and Operation/Oxygen Sensor Unit Protective Pipes.
‹› Use the faulty sensor as a guide for installing all of the accompanying attachments, cable ties or marking bands.
‹› Do not repair the oxygen sensor wires. Repairing may result in malfunctions.
-
Remove the faulty oxygen sensor.
-
Lay both of the oxygen sensor next to each other so the sensor housings are the same level.
-
Tie the excess length of the sensor (approximately 50 to 250 mm) back so it is the same length as the faulty sensor and secure it with cable ties - 1
-.
-
Check if the oxygen sensor connector housing is compatible with the vehicle electrical system side.
-
If necessary, replace the vehicle electrical system connector with the provided oxygen sensor connector housing. Refer to => [ Contacts in Contact
Housing, Repairing ] See: Power and Ground Distribution/Wiring Harness/Service and Repair/Procedures/Contacts In Contact Housing, Repairing
.