Eos (1F7) V6-3.2L (BUB) (2008)
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Engine Control Module (ECM) (J623 ). Refer to => [ Engine Control Module J623, Replacing ] See: Engine Control Module/Service
and Repair/Engine Control Module J623, Replacing.
-
Assembly is performed in the reverse of the removal.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing
and Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes.
End of diagnosis
Oxygen Sensors G130 and G131, Checking
Oxygen Sensors G130 and G131, Checking
The following procedure is used to diagnose both Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) and the Oxygen
Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) (G131)
‹› Vehicle must be raised before the electrical connector of the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130)and
Oxygen Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) (G131) is accessible.
‹› When servicing terminals 3 and 4 in the electrical harness connector of the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC)
(G130) and Oxygen Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) (G131), use only gold-plated terminals.
Special tools, testers and auxiliary items required
‹› Multimeter.
‹› Wiring diagram.
Test requirements
‹› The Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130)and Oxygen Sensor (O2S) 2 Behind Three Way Catalytic
Converter (TWC) (G131) fuses Ok.
‹› Oxygen Sensor (O2S) 1 (behind Three Way Catalytic Converter (TWC)) Heater ( Z29) and Oxygen Sensor (O2S) 2 (behind Three Way Catalytic
Converter (TWC)) Heater (Z30) OK.
‹› Battery voltage at least 12.5 volts.
‹› All electrical consumers such as, lights and rear window defroster, switched off.
‹› Vehicles with automatic transmission, selector lever in position " P" or "N".
‹› A/C switched off.
‹› Ground (GND) connections between engine/transmission/chassis OK.
‹› Exhaust system between catalytic converter and cylinder head properly sealed.
‹› Coolant Temperature at least 80° C.
Test procedure