Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Service and Repair > Engine Control Module, Without Anti-Theft Immobilizer

Page 1
background image

Engine Control Module: Service and Repair
Engine Control Module, Without Anti-Theft Immobilizer

Engine Control Module, without Anti-Theft Immobilizer

‹› If it is desired to replace the Engine Control Module (ECM), connect the vehicle diagnostic tester and perform the guided function " Replace

Engine Control Module (ECM)".

Removing

-

Turn off the ignition.

-

Remove the windshield wiper arms, plenum chamber cover and plenum chamber facing wall.

-

Disconnect the front connector - 1 - from the ECM.

-

Pry up the locking mechanism - 2 - slightly.

-

Slide the ECM out of the bracket in the - direction of the arrow -.

-

Disconnect the rear connector from the ECM.

Installing

-

Connect and lock the rear connector to the ECM.

-

Slide the ECM into the bracket.

-

Connect and lock the front connector to the ECM.

-

Install plenum chamber facing wall, plenum chamber cover and windshield wiper arms.

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Service and Repair > Engine Control Module, Without Anti-Theft Immobilizer

[PREV PAGE] [NEXT PAGE]