Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Powertrain Management > Computers and Control Systems > Throttle Position Sensor > Component Information > Locations > Page 3067
Throttle Position Sensor: Testing and Inspection
Throttle Position Sensor G79 and Accelerator Pedal Position Sensor 2 G185, Checking
Special tools, testers and auxiliary items required
‹› Wiring diagram
‹› The Engine Control Module (ECM) ( J623) fuses OK.
‹› Battery voltage at least 12.5 volts.
‹› All electrical consumers such as, lights and rear window defroster, switched off.
‹› Vehicles with automatic transmission, shift selector lever into position " P" or "N".
‹› A/C switched off.
‹› Ground (GND) connections between engine/transmission/chassis OK.
‹› Use only gold-plated terminals when servicing the electrical harness connector terminals in Throttle Position (TP) Sensor (G79 )/Accelerator
Pedal Position Sensor 2 (G185).
Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] See: Testing and Inspection/Scan Tool Testing
Remove the drivers side storage compartment.
Disconnect the Throttle Position (TP) Sensor ( G79)/Accelerator Pedal Position Sensor 2 (G185 ) 6-pin electrical harness connector - 2 -.
|[PREV PAGE] [NEXT PAGE]|