Eos (1F7) V6-3.2L (BUB) (2008)
Specified value: 1.5 ohms max.
If the specification is not obtained:
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and the voltage supply was OK:
Replace the Throttle Position (TP) Sensor (G79 )/Accelerator Pedal Position Sensor 2 (G185).
If no malfunction is detected in the wiring and if the voltage supply was not OK:
Erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 04 - Erase DTC Memory
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to => [ Readiness Code Description ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
Replace the Engine Control Module (ECM) (J623 ). Refer to => [ Engine Control Module J623, Replacing ] See: Engine Control Module/Service
and Repair/Engine Control Module J623, Replacing.
Assembly is performed in the reverse of the removal.