Eos (1F7) V6-3.2L (BUB) (2008)
‹› (T10068 A) must not be installed during this process.
-
Tighten the new bolts for the camshaft adjusters to 60 Nm + 90° (1/4) additional turn.
If replacing the seals in the camshaft front cover, refer to => [ Camshaft Front Cover
Seal, Installing ] See: Engine, Cooling and Exhaust/Engine/Cylinder Block Assembly/Balance Shaft Chain/Service and Repair.
-
Clean the sealing surfaces on the cover and on the cylinder head.
-
Lubricate the oil passage seal O-ring - 1 - and insert it in the cover.
-
Make sure the alignment sleeves - 2 and 3 - are installed.
-
Install the seal - 4 - in the cover.
-
Clean the old sealing compound from the 3 mm holes in the cylinder head gasket - arrows -.
-
Fill the 3 mm holes in the cylinder head gasket with sealant (D 176 501 A1). Apply sealant (D 176 501 A1) to the sealing surfaces on the cover
and install the cover immediately.
-
Install all the camshaft front cover bolts - arrows - and tighten lightly.