Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Powertrain Management > Fuel Delivery and Air Induction > Fuel Pump > Fuel Pressure > System Information > System Diagnosis > Fuel Pump Electrical, Testing > Page 3246

Page 4
background image

After repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and

Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09 [ (BPY)  (BUB) ]/Diagnostic Mode 03 - Read DTC Memory.

2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and

Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09 [ (BPY)  (BUB) ]/Diagnostic Mode 04 - Erase DTC Memory. 

3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and

Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.

End of diagnosis

Powertrain Management > Fuel Delivery and Air Induction > Fuel Pump > Fuel Pressure > System Information > System Diagnosis > Fuel Pump Electrical, Testing > Page 3246

[PREV PAGE] [NEXT PAGE]