Eos (1F7) V6-3.2L (BUB) (2008)
Specified value: infinite (Infinity).
If the specified value was not obtained:
Replace the faulty Knock Sensor (KS) 1 (G61)/Knock Sensor (KS) 2 (G66).
If the specified value was obtained:
If the manufacturers test box is being used. Perform the following step.
Install the Test Box 105 Pin (VAG1598/31).
If the manufacturers test box is not being used. Perform the following step.
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module J623, Replacing ] See: Computers and Control
Systems/Engine Control Module/Service and Repair/Engine Control Module J623, Replacing.
Using a Multimeter, Check the Knock Sensor electrical harness connector to the Engine Control Module (ECM) (J623) electrical harness
connector T121 for an open circuit.