Eos (1F7) V6-3.2L (BUB) (2008)
Specified value: about 5.0 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin (VAG1598/31).
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module J623, Replacing ] See: Computers and Control
Systems/Engine Control Module/Service and Repair/Engine Control Module J623, Replacing.
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor (G40) or Camshaft Position (CMP) Sensor 2 (G163) electrical harness connector
to the Engine Control Module (ECM) electrical harness connector T121 for an open circuit.