Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Testing and Inspection > Functions, Checking > Page 2607

Page 1
background image

Oxygen Sensor: Testing and Inspection
Oxygen Sensor Heaters Z19 and Z28, Checking

Oxygen Sensor Heaters Z19 and Z28, Checking

The following procedure is used to diagnose Oxygen Sensor (O2S) Heater (Z19) and Oxygen Sensor (O2S) 2 Heater (Z28).

‹› When servicing electrical harness connector terminals for the Heated Oxygen Sensor (HO2S), use only gold-plated terminals. 

Special tools, testers and auxiliary items required

‹› Multimeter.

‹› Wiring diagram.

Test requirements

‹›  The Heated Oxygen Sensor (HO2S) Fuse 11 (on fuse panel B) (SB11) OK.

‹› Battery voltage at least 12.5 volts.

‹› All electrical consumers such as, lights and rear window defroster, switched off.

‹› Vehicles with automatic transmission, shift selector lever into position " P" or "N".

‹› A/C switched off.

‹› Ground (GND) connections between engine/transmission/chassis OK.

‹› Ignition switched off.

Test procedure

-

Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] See: Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Preliminary Check

Start diagnosis

Checking internal resistance

-

Disconnect the Heated Oxygen Sensor (HO2S) (G39 ) electrical harness connector - 2 - or the Heated Oxygen Sensor (HO2S) 2 (G108) electrical
harness connector- 1 -.

-

Using a multimeter, check the Heated Oxygen Sensor (HO2S) terminals 3 to 4 for an open circuit.

Specified value: 2.5 to 10.0 ohms (at approx. 20° C)

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Testing and Inspection > Functions, Checking > Page 2607

[PREV PAGE] [NEXT PAGE]