Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Ignition Switch > Ignition Switch Lock Cylinder > Component Information > Service and Repair > Steering Column Switch Components, to 10.09

Page 1
background image

Ignition Switch Lock Cylinder: Service and Repair
Steering Column Switch Components, to 10.09

Steering Column Switch Components, To 10.09

Lock Cylinder

CAUTION!
‹› When disconnecting and connecting battery, the procedure must be followed as described in the Repair Information => [

Disconnecting and Connecting Battery In Engine Compartment ] See: Starting and Charging/Battery/Service and Repair/Removal
and Replacement/Disconnecting and Connecting Battery In Engine Compartment or => [ Disconnecting and Connecting Batteries In
Luggage Compartment ] See: Starting and Charging/Battery/Service and Repair/Removal and Replacement/Disconnecting and
Connecting Batteries In Luggage Compartment.

‹› Steering lock may be destroyed.

‹› If steering lock is operated without lock cylinder, it locks and must be replaced.

‹› Steering lock must not be operated without lock cylinder.

Removing:

-

Disconnect battery. Refer to => [ Disconnecting and Connecting Battery In Engine Compartment ] See: Starting and Charging/Battery/Service and
Repair/Removal and Replacement/Disconnecting and Connecting Battery In Engine Compartment or => [ Disconnecting and Connecting Batteries
In Luggage Compartment ] See: Starting and Charging/Battery/Service and Repair/Removal and Replacement/Disconnecting and Connecting
Batteries In Luggage Compartment.

-

Remove driver's side airbag unit.

-

Remove steering wheel.

-

Remove the steering column trim.

‹› For reasons of clarity, the figure does not show the turn signal switch and windshield wiper switch. Switches must not be removed when removing

lock cylinder.

‹› The immobilizer induction coil is attached to the lock cylinder and cannot be replaced separately.

-

Insert ignition key into lock cylinder and turn it into position Drive.

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Ignition Switch > Ignition Switch Lock Cylinder > Component Information > Service and Repair > Steering Column Switch Components, to 10.09

[PREV PAGE] [NEXT PAGE]